RE: [baidarka] chine stringers

Subject: RE: [baidarka] chine stringers
From: Bob La Quey (boblq@cox.net)
Date: Sat Nov 08 2003 - 00:39:07 EST

• Next message: steve: "[baidarka] skin difference"
• Previous message: Gerald Maroske: "Re: [baidarka] lower rear coaming on baidarka"
• In reply to: Aaron Cunningham: "RE: [baidarka] chine stringers"
• Next in thread: Aaron Cunningham: "RE: [baidarka] chine stringers"
• Reply: Bob La Quey: "RE: [baidarka] chine stringers"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]

At 07:38 PM 11/7/2003 -0800, you wrote:
>Mine were 'hand made' 3/8" dowel milled from SPF planks, and they just
>flexed into place without forcing them.
>
>Aaron

How do you 'hand made' dowel?

boblq
-
Baidarka Mailing List - All postings copyright the author and not to be
reproduced outside Baidarka or Baidarka archives without author's permission
Submissions: baidarka@paddlewise.net
Subscriptions: baidarka-request@paddlewise.net
Searchable archive: http://rtpnet.org/robroy/baidarka

• Next message: steve: "[baidarka] skin difference"
• Previous message: Gerald Maroske: "Re: [baidarka] lower rear coaming on baidarka"
• In reply to: Aaron Cunningham: "RE: [baidarka] chine stringers"
• Next in thread: Aaron Cunningham: "RE: [baidarka] chine stringers"
• Reply: Bob La Quey: "RE: [baidarka] chine stringers"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]

This archive was generated by hypermail 2b27 : Mon Dec 01 2003 - 01:30:01 EST